类型 | 描述 |
---|
安装方式 | Surface Mount |
引脚数 | 20 Pin |
电源电压 | 2.00V ~ 5.50V |
封装 | VQFN-20 |
电路数 | 8 Circuit |
通道数 | 8 Channel |
位数 | 8 Bit |
电压波节 | 5.00 V, 3.30 V, 2.50 V |
输出电流驱动 | -1.00 mA |
工作温度(Max) | 125 ℃ |
工作温度(Min) | -40 ℃ |
电源电压 | 2V ~ 5.5V |
电源电压(Max) | 5.5 V |
电源电压(Min) | 2 V |
类型 | 描述 |
---|
产品生命周期 | Active |
包装方式 | Tape & Reel (TR) |
工作温度 | -40℃ ~ 125℃ (TA) |
逻辑类型Logic Type| 收发器,非反相 Transceiver, Non-Inverting \---|--- 电路数Number of Circuits| 1 输入数Number of Inputs| 8 电源电压VccVoltage - Supply| 2 V ~ 3.6 V 静态电流IqCurrent - Quiescent (Max)| 16mA,16mA 输出高,低电平电流Current - Output High, Low| OCTAL BUS TRANSCEIVERS WITH 3-STATE OUTPUTS description/ordering information (continued) The ’LV245A devices are designed for asynchronous communication between data buses. The device transmits data from the A bus to the B bus or from the B bus to the A bus, depending on the logic level at the direction-control (DIR) input. The output-enable (OE) input can be used to disable the device so the buses are effectively isolated. To ensure the high-impedance state during power up or power down, OE should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver. These devices are fully specified for partial-power-down applications using Ioff The Iof circuitry disables the outputs, preventing damaging current backflow through the devices when they are powered down. 2-V to 5.5-V VCC Operation Max tpd of 6.5 ns at 5 V Typical VOLP (Output Ground Bounce) <0.8 V at VCC = 3.3 V, TA = 25°C Typical VOHV (Output VOH Undershoot) >2.3 V at VCC = 3.3 V, TA = 25°C Support Mixed-Mode Voltage Operation on All Ports off Supports Partial-Power-Down Mode Operation Latch-Up Performance Exceeds 250 mA Per JESD 17 ESD Protection Exceeds JESD 22 2000-V Human-Body Model (A114-A) 200-V Machine Model (A115-A) 1000-V Charged-Device Model (C101 低逻辑电平Logic Level - Low| 具有三态输出的八路总线收发器 描述/订购信息(续) "LV245A设备是专为数据总线之间的异步通信。该装置 发送数据从A总线到B总线或从B总线到A总线,这取决于对逻辑电平 方向控制(DIR)输入。输出使能(OE)输入可用于禁用设备,以便巴士 有效隔离。 为了确保在开机或断电高阻抗状态,OE应当连接到VCC通过上拉 电阻,电阻的最小值确定的驱动器的电流吸收能力。 这些器件是完全指定部分断电应用程序使用IOFF IOF电路将禁用 输出,防止损坏电流回流通过这些器件的时候都 断电。 “2 V至5.5 V的VCC操作 最大5 V时为6.5 ns吨 典型的VoIP(输出地弹跳) <0.8 V在VCC =3.3 V,TA= 25°C 典型的VOHV(输出VOH冲) >2.3 V在VCC =3.3 V,TA= 25°C 支持混合模式的工作电压 关闭所有端口支持部分掉电模式 手术 闭锁性能超过250 mA每 JESD17 ESD保护超过JESD22 2000-V人体模型(A114-A) 200-V机型号(A115-A) 1000-V带电器件模型(C101“ 高逻辑电平Logic Level - High| 传播延迟时间@Vcc,CLMax Propagation Delay @ V, Max CL| Description & Applications| 描述与应用|
TI(德州仪器)
21 页 / 5.57 MByte
TI(德州仪器)
18 页 / 0.55 MByte
TI(德州仪器)
TEXAS INSTRUMENTS SN74LV245APWR 收发器, 3态, 非反相, 2 V至5.5 V, TSSOP-20
TI(德州仪器)
TEXAS INSTRUMENTS SN74LV245ADW 收发器, 非反相, 3态, 2V至5.5V, SOIC-20
TI(德州仪器)
IC 总线收发器 SN74LV245ARGYR VFQFN-20 marking/标记 LV245A
TI(德州仪器)
八路总线收发器与3态输出 OCTAL BUS TRANSCEIVERS WITH 3-STATE OUTPUTS
TI(德州仪器)
八路总线收发器与3态输出 OCTAL BUS TRANSCEIVERS WITH 3-STATE OUTPUTS
TI(德州仪器)
八路总线收发器与3态输出 OCTAL BUS TRANSCEIVER WITH 3-STATE OUTPUTS
TI(德州仪器)
TEXAS INSTRUMENTS SN74LV245APW 收发器, 非反相, 3态, 2V至5.5V, TSSOP-20
TI(德州仪器)
八路总线收发器与3态输出 OCTAL BUS TRANSCEIVER WITH 3-STATE OUTPUTS
TI(德州仪器)
八路总线收发器与3态输出 OCTAL BUS TRANSCEIVERS WITH 3-STATE OUTPUTS
TI(德州仪器)
八路总线收发器与3态输出 OCTAL BUS TRANSCEIVERS WITH 3-STATE OUTPUTS
器件 Datasheet 文档搜索
数据库涵盖高达 72,405,303 个元件的数据手册,每天更新 5,000 多个 PDF 文件